Plastic UV coating (Thin coating type)
Composition: polyurethane propionate, active diluent, photoinitiator, additive and solvent.
Uses: Used in ABS, ABS+PC, nylon + glass fiber and other substrates, such as mobile phones, buttons, MP3, MP4, digital cameras, watches, cosmetic cases, laptop and other plastic shell, suitable for thin coating.
The 3100F is an all-mute model.
Product characteristics
1.UV drying, fast speed; Suitable for spraying operation mode, easy construction
2. Excellent solvent resistance, good yellowing resistance, excellent wear resistance
3. The coating has good toughness, smoothness and high gloss
4. With high fullness, excellent adhesion, high hardness, good scratch resistance
|
Appearance: transparent liquid |
Viscosity: 15±2 seconds (NK#2 cups 25℃) |
|
Adhesion: 100/100(grid method) |
Exposure intensity: 600mj-800mj/cm² |
|
Hardness: H-2H(Mitsubishi pencil) |
Storage stability: 6 months |
|
Solvent resistance: 99% alcohol cotton cloth ×500g/cm²×500 times |
|
|
Friction resistance: RCA175g 500 cycles |
|
|
Resistance to artificial sweat: 50℃ constant temperature bubbling for 48 hours, wipe with wet gauze 20 times, light oil does not fall off |
|
|
Hot and cold cycle: -20℃× 2H-65 ℃×2h×10 cycles |
|
Notes
1. If it is not a matching primer, please test the adhesion of the coating first, and confirm that it can be used in batch after meeting the requirements;
2. During the operation of this product, pay attention to the spray film thickness control to avoid vertical flow and other adverse phenomena;
3. When adding dyes, the solubility should be measured in advance, and then added to the paint after no problem;
4. If the product is stuck on the skin, rinse it immediately with water; Unused coatings should be sealed to avoid viscosity increase and stored in a dark, dry and ventilated place.
-
LAST ONE：JF8100 series
-
NEXT ONE：JF-3900 series